Sign in to follow this  
Followers 0
welditup

I have a bunch of CELs. Help plzzzz

1 post in this topic

I plugged in my scan tool today and was surprised how many codes I got. I have a total of 18 codes with some of them repeated more than once. Any tips or suggestions before I start wrenching on it this weekend? I want to take the right approach to this and some help would be very much appreciated. I'm going to start with checking my wires for any mix up but everything was pretty much fool proof. I had everything marked and numbered and the only thing I had to wire up was the o2 sensors. All the other connections had harnesses so it just clicked together. 

p0303- #3 misfire

p0015- exhaust cam shaft over retarded

p0351- ignition coil a primary secondary circuit

p0234- turbo charger overboost condition

p0236- turbo charger boost sensor A circuit

p0108- manifold absolute pressure bar sensor high input

p0102- mass or volume air flow low input

p0505- idle air control system

p0014- exhaust camshaft position timing over retarded bank 1

p0303- cylinder 3 misfire detected

p0351- ignition coil a primary secondary circuit

p0234- turbo overboost condition

p0236- turbo overboost sensor A circuit

p0108- manifold absolute pressure high sensor high input

p0102- mass or volume air fow circuit low input

p0505- idle air control system

p0014- exhaust camshaft position over advanced

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0