tandrassy

Members
  • Content count

    19
  • Joined

  • Last visited

About tandrassy

  • Rank
    Fairly R
  • Birthday 12/29/1974

Contact Methods

  • MSN
    tandrassy@hotmail.com
  • Website URL
    http://www.carstyling.hu/car_shower.php?id=13089
  • ICQ
    302825401

Profile Information

  • Gender
    Male
  • Location
    Budapest, Hungary (Europe)
  • Interests
    Cars
  1. I replaced the cracked manifold. http://kepfeltoltes.hu/151208/201512073134_www.kepfeltoltes.hu_.jpg http://kepfeltoltes.hu/151208/201512073135_www.kepfeltoltes.hu_.jpg http://kepfeltoltes.hu/151208/201512073136_www.kepfeltoltes.hu http://kepfeltoltes.hu/151208/201512073137_www.kepfeltoltes.hu_.jpg
  2. ET44 between 1996 and 2004.
  3. Heat shield changing procedure.
  4. Hi ! Facing the transmision... Polyamide automatic-adjusting wedges melted, sticked together paltes. It had a hammer to smash. It was the last time when used dual mass flywheel. Tom
  5. Congratulations for Sachs ! Your new clutch contain thermoplastic(danamid) wedge-disc for automatic self-adjuster. Do not slip, do not trailer because it will be short life-time. Very short !
  6. Regeneration of my pulverized car-keys... http://imgfrm.index.hu/imgfrm/3/3/4/0/BIG_0013143340.jpg http://imgfrm.index.hu/imgfrm/3/3/4/2/BIG_0013143342.jpg http://imgfrm.index.hu/imgfrm/3/3/4/4/BIG_0013143344.jpg http://imgfrm.index.hu/imgfrm/3/3/4/5/BIG_0013143345.jpg http://imgfrm.index.hu/imgfrm/3/3/4/7/BIG_0013143347.jpg
  7. 312cc ---> 420cc Maybe, but change inlet manifold too. After it please reset adaptation for EMS2000 (need factory odb2 multitester + S/V40 mc), then will working properly.
  8. Mercury Cougar made by Ford, or not ? In 2002 Ford own Volvo. But I have old gearboxes with 20 spline shafts...
  9. 6 sprung hub centre, gearshaft: 23,3 x 26,3 x 23 spline, maximal torqe 520 Nm, if it isn't too small for yor setup
  10. Clutch plate not compatible, only the disc.
  11. Yes. And 6 springs indisc.
  12. Lancer EVO8 have 240mm clutch disc with 23 spline shaft...
  13. It is 227mm clutch for dual-mass flywheel. Suitable old M56s. If you using it on single-mass flywheel, then will be very noisy gearbox-bearings and damaged.
  14. The new concentric clutch cylinder rare under $70.
  15. "Also for anyone using the 850R clutch with an internal slave, do you need the release fork like with the external slave models?" No, only the hydraulic pipe needs disconnecting.